Latest Products
-
2WD aluminium robot chassis - RED
19.90€
-
2WD aluminium robot chassis - BLUE
19.90€
-
MINI360 3A MINI DC-DC STEP DOWN CONVERTER VOLT REGULATOR 5V-23V TO 3. 6V 9V 12V
2.62€
-
5V Power Bank circuit board
4.17€
-
Micro Usb to Dip
2.96€
-
ICS43432 I2S Digital Microphone
10.12€
-
LED breakout module
4.17€
-
Adafruit I2S MEMS Microphone Breakout - SPH0645LM4H
10.12€
-
GY-4466 Professional MAX4466 High Precision Electret Microphone Amplifier with Adjustable Gain for Arduino
7.14€
-
DC to DC HW613 step down
2.38€
-
Nand gate
1.19€
-
38KHz Infrared IR Receiver Sensor Module Geekcreit for Arduino ( Copy )
1.79€
-
Potentiometer 10k Ohms
0.36€
-
OP-AMP
1.19€
-
2N3904 transistor
1.19€
-
Raindrops Detection Sensor Module Compatible with Arduino
8.33€
-
PCB LoRa antenna
5.36€
-
Photoresistor Photo Light Sensitive Resistor Light Dependent Resistor
1.19€
-
helical coil antenna
5.36€
-
ARCELI DC to DC step down
2.98€
-
22402A-18 protoboard one side 5X7 cm
3.45€
-
22402A-18 protoboard two sided 5x7 cm
3.45€
-
22402A-18 protoboard two sided 4x6 cm
3.45€
-
22402A-17 protoboard two sided 2x8 cm
3.45€
-
22402A-17 protoboard two sided 3x7 cm
3.45€
-
WHITE LED's 5mm
0.36€
-
NeoPixel Stick - 8 x 5050 RGB LED with Integrated Drivers
5.95€
-
WHITE LED's 3mm
0.30€
-
mini push button switch 4 pin ( Copy )
0.60€
-
rocket switch 2 pin
0.60€
-
New Led Ring 16x 5050 RGB LED Board with Integrated Drivers Module Geekcreit for Arduino - products that work with official Arduino boards
7.14€
-
Slide switch 3 pin
0.60€
-
New LED Ring 24 x WS2812 5050 RGB LED with Integrated Drivers
9.52€
-
10 Grid Digital Segment LED Light Bar 10 Flat Tube of Super Bright 2 Red+3 Yellow+4 Green+1 Blue Light Flat Tube ( Copy )
4.17€
-
tactile switch 6 pin
0.60€
-
BLUE LED's 5mm
0.36€
- Traceable
- Cable-Free Readings
- Monitor Up to Three Sensors Simultaneously
Thermometer receives a wireless radio signal from the remote sensor module, which transmits a temperature signal on a frequency of 433mHz. Place the main unit on a desk or bench, and the remote sensor module on fume hoods, refrigerators, incubators, storage facilities, or even outdoors. Signal ranges from 19.8–39.6m (65–130').
Thermometer displays transmitted data every 30 seconds on LCD readout. Digits are 2.9cm (11/8") high. Display indicates rising or falling temperature. An alarm may be set in 1° increments. Alarm sounds when temperature rises above or falls below the two set points. Minimum and maximum memory readouts allow monitoring of conditions overnight, weekly, or for any time period. Unit can monitor three different remote sensor modules simultaneously. Case is high-impact, chemical-resistant ABS plastic.
The splash-proof remote sensor module is equipped with an internal sensor and an external sensor probe with 3m (10') cable. Module probe and cable perform accurately, even when under water. Case is high-impact, chemical-resistant ABS plastic.
Stainless steel probe accessory 21800-030 has a 1.5m (5') cable and can be used with liquids, air/gas, or semisolids. External bottle probe accessory 21800-008 is sealed in a mini-bottle filled with a glycol solution for temperature buffering. It monitors products subjected to door openings in freezers, refrigerators, and incubators. Vaccine bottle probe 89094-784 is a sensor probe sealed in a 5mL bottle filled with GRAS nontoxic glycol. The bottle mimics vaccine temperature and fits in a vaccine tray.
Thermometers fulfill all CDC thermometer and vaccine thermometer requirements. A serial numbered certificate is provided from an ISO 17025 calibration laboratory accredited by A2LA to indicate instrument traceability to standards provided by the National Institute of Standards and Technology.
- Availability: 1
- Model: 21800-002