Latest Products
-
2WD aluminium robot chassis - RED
19.90€
-
2WD aluminium robot chassis - BLUE
19.90€
-
MINI360 3A MINI DC-DC STEP DOWN CONVERTER VOLT REGULATOR 5V-23V TO 3. 6V 9V 12V
2.62€
-
5V Power Bank circuit board
4.17€
-
Micro Usb to Dip
2.96€
-
ICS43432 I2S Digital Microphone
10.12€
-
LED breakout module
4.17€
-
Adafruit I2S MEMS Microphone Breakout - SPH0645LM4H
10.12€
-
GY-4466 Professional MAX4466 High Precision Electret Microphone Amplifier with Adjustable Gain for Arduino
7.14€
-
DC to DC HW613 step down
2.38€
-
Nand gate
1.19€
-
38KHz Infrared IR Receiver Sensor Module Geekcreit for Arduino ( Copy )
1.79€
-
Potentiometer 10k Ohms
0.36€
-
OP-AMP
1.19€
-
2N3904 transistor
1.19€
-
Raindrops Detection Sensor Module Compatible with Arduino
8.33€
-
PCB LoRa antenna
5.36€
-
Photoresistor Photo Light Sensitive Resistor Light Dependent Resistor
1.19€
-
helical coil antenna
5.36€
-
ARCELI DC to DC step down
2.98€
-
22402A-18 protoboard one side 5X7 cm
3.45€
-
22402A-18 protoboard two sided 5x7 cm
3.45€
-
22402A-18 protoboard two sided 4x6 cm
3.45€
-
22402A-17 protoboard two sided 2x8 cm
3.45€
-
22402A-17 protoboard two sided 3x7 cm
3.45€
-
WHITE LED's 5mm
0.36€
-
NeoPixel Stick - 8 x 5050 RGB LED with Integrated Drivers
5.95€
-
WHITE LED's 3mm
0.30€
-
mini push button switch 4 pin ( Copy )
0.60€
-
rocket switch 2 pin
0.60€
-
New Led Ring 16x 5050 RGB LED Board with Integrated Drivers Module Geekcreit for Arduino - products that work with official Arduino boards
7.14€
-
Slide switch 3 pin
0.60€
-
New LED Ring 24 x WS2812 5050 RGB LED with Integrated Drivers
9.52€
-
10 Grid Digital Segment LED Light Bar 10 Flat Tube of Super Bright 2 Red+3 Yellow+4 Green+1 Blue Light Flat Tube ( Copy )
4.17€
-
tactile switch 6 pin
0.60€
-
BLUE LED's 5mm
0.36€
Unit protects against contamination in sensitive PCR amplification reactions. UV irradiation of working area prior to use blocks replication of contaminating DNA sequences by causing adjacent pyrimidines to undergo dimerization. Workstation protects against airborne or cross-contamination by limiting exposure of experimental setup to open lab environment.
The 12-hour count-down timer with time-hold position (supplied with the UV germicidal lamp) conveniently controls PCR workstation decontamination. To decontaminate, the user simply UV-irradiates the work area with doors closed prior to PCR procedure and just after use. The acrylic, non-ventilated PCR workstation measures 61Hx61Dcm (24x24") and is available in widths of 76.2cm (30"), 91.4cm (36") (single door closure), and 121.9cm (48") (double door closure).
Dual UV bulb option decreases the possibility of PCR amplification of contaminating DNA by delivering twice the intensity of UV light and irradiating what otherwise might be shadowed areas. The Dual UV bulb format is recommended when the workstation will be used to decontaminate apparatus and reagents.
Choose between an acid resistant black laminate or stainless steel work surface. Each PCR workstation is equipped with the following: tempered safety glass fascia, duplex 110V electrical outlet mounted in ceiling (for domestic use), two fluorescent lamps, one or two (dependent on single or dual) UV germicidal (250nm) lamps with 12-hour timer, and single or double door closures.
Accessory table and accessory locking casters transform the PCR workstation into a moveable work area that doesn’t infringe on valuable benchtop work space.
Ordering Information: Gascock CB-TCG and vacuum cock CB-TCV are factory installed. PCR workstations are available with 220V electrical option for international use; contact your VWR sales representative for more information.
- Availability: 1
- Model: CBP-036-202