Latest Products
-
2WD aluminium robot chassis - RED
19.90€
-
2WD aluminium robot chassis - BLUE
19.90€
-
MINI360 3A MINI DC-DC STEP DOWN CONVERTER VOLT REGULATOR 5V-23V TO 3. 6V 9V 12V
2.62€
-
5V Power Bank circuit board
4.17€
-
Micro Usb to Dip
2.96€
-
ICS43432 I2S Digital Microphone
10.12€
-
LED breakout module
4.17€
-
Adafruit I2S MEMS Microphone Breakout - SPH0645LM4H
10.12€
-
GY-4466 Professional MAX4466 High Precision Electret Microphone Amplifier with Adjustable Gain for Arduino
7.14€
-
DC to DC HW613 step down
2.38€
-
Nand gate
1.19€
-
38KHz Infrared IR Receiver Sensor Module Geekcreit for Arduino ( Copy )
1.79€
-
Potentiometer 10k Ohms
0.36€
-
OP-AMP
1.19€
-
2N3904 transistor
1.19€
-
Raindrops Detection Sensor Module Compatible with Arduino
8.33€
-
PCB LoRa antenna
5.36€
-
Photoresistor Photo Light Sensitive Resistor Light Dependent Resistor
1.19€
-
helical coil antenna
5.36€
-
ARCELI DC to DC step down
2.98€
-
22402A-18 protoboard one side 5X7 cm
3.45€
-
22402A-18 protoboard two sided 5x7 cm
3.45€
-
22402A-18 protoboard two sided 4x6 cm
3.45€
-
22402A-17 protoboard two sided 2x8 cm
3.45€
-
22402A-17 protoboard two sided 3x7 cm
3.45€
-
WHITE LED's 5mm
0.36€
-
NeoPixel Stick - 8 x 5050 RGB LED with Integrated Drivers
5.95€
-
WHITE LED's 3mm
0.30€
-
mini push button switch 4 pin ( Copy )
0.60€
-
rocket switch 2 pin
0.60€
-
New Led Ring 16x 5050 RGB LED Board with Integrated Drivers Module Geekcreit for Arduino - products that work with official Arduino boards
7.14€
-
Slide switch 3 pin
0.60€
-
New LED Ring 24 x WS2812 5050 RGB LED with Integrated Drivers
9.52€
-
10 Grid Digital Segment LED Light Bar 10 Flat Tube of Super Bright 2 Red+3 Yellow+4 Green+1 Blue Light Flat Tube ( Copy )
4.17€
-
tactile switch 6 pin
0.60€
-
BLUE LED's 5mm
0.36€
Blue metal platform for building a robot. Included are two DC motors with wheels with 65 mmdiameter. elements of the chassis is made of metal. It has mounting holes, allowing you to install all kinds of sensors, controllers (including Arduino,Raspberry Pi and others).
In order to start the robot, it is sufficient to assemble the platform, screw on the engine, install the wheels and add any robot controller (e.g.Arduino Uno with Motor Shield). The power source may be AA batteries. There are some sensors that can extend the robot's capabilities.
Set includes
- Metal platform in blue
- Two-wheel white with tires with 65 mm diameter
- Two DC motors with gearboxes
- Metal parts (screws, nuts, etc.)
- Support wheel
Specification
- Supply voltage of motors: 3 V to 6 V
- Motor speed without load: 60-120 rpm
- Current consumption of motor at no load: 80 mA (max 100 mA)
- Current consumption of the motor at the fixed shaft 1, And
- Wheels:
- Diameter: 65 mm
- Width: 15 mm
- Plastic wheels with rubber tires
- Design size: 170 x 90 x 30 mm
- Weight: approx. 200 g
- Availability: 3